Motion-pro 01-0511 Manuel d'utilisateur télécharger pdf

IMPORTANT - READ BEFORE INSTALLING

THIS KIT IS TO BE INSTALLED BY A TRAINED TECHNICIAN IN A PROPERLY EQUIPPED SHOP

FOR THROTTLE KIT P/N 01-0337, P/N 01-0350, P/N 01-0500,

P/N 01-0511 (YFS 200 BLASTER)

NOTE: When this kit is used with stock carburetors it will be necessary to install an idle kit P/N 08-0045.

THESE INSTRUCTIONS ARE FOR USE WITH TWIST GRIP TYPE THROTTLE KITS. THESE KITS ARE

DESIGNED TO REPLACE THE ORIGINAL THUMB THROTTLE WITH A TWIST GRIP TYPE THROTTLE.

1. Remove the seat and fuel tank. Carefully observe how the stock throttle cable is routed from the

thumb throttle to the carburetor. This is how you will want to route the new cable.

2. Temporarily remove any clamps or guides used to retain the throttle cable. Remove the stock thumb

throttle assembly.

3. Before removing the carburetor top/switch assembly, clean the outside of the carburetor and switch

assembly thoroughly. On the outside of the carburetor you will find a gold colored carburetor top locking

plate (original equipment carburetor). Remove this plate and unscrew the carburetor top. Remove the

carburetor top/switch assembly. Do not allow any dirt or foreign material to enter the opening left in

carburetor. Placing a clean rag in the opening of the carburetor will help avoid this problem. ANY DIRT

OR FOREIGN MATERIAL THAT ENTERS THE CARBURETOR CAN CAUSE THE THROTTLE SLIDE TO STICK.

4. Pull the spring away from the slide and remove the retaining plate. Remove the slide and spring from

the carburetor top/switch assembly (original equipment carburetor). Install the adjuster, carburetor cap,

spring and slide onto the new cable. Make sure the needle is in the correct position and reinstall the

retaining plate.

5. Remove the rag in the carburetor opening. Again, be careful that dirt or foreign material does not

enter the carburetor. Install the throttle slide into the carburetor. Make sure the guide pin slides into the

groove on the slide (slide cutaway to rear). Tighten the carburetor cap. Pull on the top cable end to

make sure the full travel (up and down) of the slide is smooth, without binding.

6. Remove the right hand grip from the handlebar. With an Allen wrench, disassemble the new throttle

assembly. Using the throttle sleeve as a guide, mark the handlebar showing where the sleeve will fit.

With fine sandpaper remove any paint on the handlebar where the throttle sleeve will fit. IT IS VERY

IMPORTANT THAT THE HANDLEBAR BE CLEAN AND SMOOTH. IF THE HANDLEBAR IS NOT CLEAN AND SMOOTH IT

IS POSSIBLE FOR THE THROTTLE TO STICK.

-OVER-

I01-0337 12/2009

1 2

IMPORTANT - READ BEFORE INSTALLING THIS KIT IS TO BE INSTALLED BY A TRAINED TECHNICIAN IN A PROPERLY EQUIPPED SHOP FOR THROTTLE KIT P/N 01-03

Page 2

7. Slide the throttle sleeve onto the handlebar. Next, install the cable through the top half of the throttle housing and connect the cable e

Modèles reliés 01-0500 | 01-0350 | 01-0337 |

Pas de commentaire