Motion-pro 08-0574 Manuel d'utilisateur télécharger pdf

CLIP ON HANDLEBAR ALIGNMENT TOOL P/N 08-0574

Thank you for purchasing this ne Motion Pro product. The tool that you have in your hands is simple and

easy to use, and will result in the accurate positioning of the clip on handlebars on your motorcycle. Take

a minute to review to following information, and you will have everything you need to use this handy tool.

Introduction:

The Clip On Handlebar Alignment Tool will allow you to compare the angle of your handlebars, and adjust

them so that the angle of sweep is the same on both sides. This tool will work with the majority of motor-

cycles, but some bikes may require the removal of an accessory (like a steering damper or fairing brack-

et) to make enough room to employ the tool.

Assembly:

Join the main arm and the secondary arm with the thumb screw. The indicating rod will thread together

through the hole in the other end of the secondary arm.

Using the Tool:

The Aligner works by setting the tool up on one side of the handlebars, and then moving it to the other

handlebar, using it to indicate the proper position of that handlebar. Place the tool so that the main blue

arm of the tool is across the front or the back of the forks. The arm can be placed against the fork tube it-

self, the fork cap, the hex on the cap, or the spring preload adjusters, whatever works best for your setup.

The main arm of the tool must be parallel to a center line drawn between the centers on the forks.

Next, align the notch on the end of the main arm with the center of the fork tube that is opposite from the

handlebar you are measuring. Once the main arm is in this location, do not allow it to move through the

next step.

Now move the secondary arm so that the indicating pin comes into contact with the handlebar. Tighten

the pivot thumbscrew securely, so that the secondary arm cannot move. Carefully remove the tool from

the forks, being careful to not allow the angle of the secondary arm to change.

INSTRUCTIONS

Process Black

White

White/Black MOTION PRO, INC. LOGO

Motion Pro, Inc.

867 American Street

Tel 650.594.9600 Fax 650.594.9610

www.motionpro.com

I08-0574 042014

1 2

INSTRUCTIONS 1

Résumé du contenu

Page 1 - INSTRUCTIONS

CLIP ON HANDLEBAR ALIGNMENT TOOL P/N 08-0574Thank you for purchasing this ne Motion Pro product. The tool that you have in your hands is simple and e

Page 2

I08-0574 042014Turn the tool over, and place it back into the same position on the forks, but this time the alignment notch will be on the opposite fo

Commentaires sur ces manuels

Pas de commentaire

Motion-pro 08-0574 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour les motocyclettes Motion-pro 08-0574. Motion Pro 08-0574 User Manual [fr] [de] [en] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour les motocyclettes Motion-pro 08-0574