Motion Pro Digital Tire Gauge P/N 08-0468
Quick Use Instructions
Press the ON/OFF button to power-up gauge. The gauge will display current pressure,
pressure unit (Psi, Kpa, etc…) and battery condition indicator. Select the desired pressure
unit by pressing the FUNCTION button until the desired pressure is shown at the bottom
of the display. Choices are Psi, Kpa, Bar and Kgf/cm2 (Note: pressure unit cannot be
changed when gauge is in hold mode. See below for details on the hold setting.)
The gauge is now ready to measure pressure. Connect the gauge to the tire valve,
the display will show the current tire pressure to the tenth (1/10) of a pound. You
may depress the chrome pressure release button on the front of the blue trapezoid
body to release excess pressure from the tire until you reach your desired pressure.
The gauge will continuously monitor the current pressure unless set to hold mode
(see below). After use of the gauge is complete it can either be turned off manually
to preserve maximum battery life or allowed to turn off automatically after the
programmed auto-off time has elapsed (see below for instructions on changing the
auto-off timer).
The backlight will shut down after 20 seconds to preserve battery life. The backlight can
be relit by pressing the FUNCTION button.
The gauge will automatically recalibrate for changes in temperature or ambient pressure
during use; however, the gauge can be manually recalibrated anytime using the Manual
Recalibration procedure described below if desired.
Note: The gauge will not hold pressure once removed from the tire valve. However, if it is
desired that the gauge does retain pressure, it can be set to hold mode and the maximum
pressure will be retained on the display until gauge is turned off or is allowed to auto-off.
Additional Features
Manual Recalibration
With the unit turned “on” and 0.0 displayed, press and hold the FUNCTION button for 5 seconds
until - - 0 – appears. Release the FUNCTION button and -000 will be displayed. Immediately press
the ON/OFF button and 0000 will display, then ash, –End will momentarily be displayed, and the
gauge display will return to 0.0. The recalibration process is now complete and the gauge is once
again ready for use.
Setting Cont and hold Functions
Note: Virtually all users will normally use the Cont (Continuous) mode for normal tire pressure readings
allowing the gauge to continuously monitor the current pressure; however, hold mode may be desirable
in certain applications where the maximum pressure reading will be retained on the display until gauge
is turned off or is allowed to auto-off.
With the unit turned “on” and 0.0 displayed, press and hold the FUNCTION button for 5 seconds until
- - 1 – appears. Release the FUNCTION button. Cont and hold will alternately be displayed. Press the
ON/OFF button when the desired mode is displayed. The selected mode will then ash, –End will momentarily
be displayed, and the gauge display will return to 0.0. The gauge is now ready for use.
Note: HOLD will be displayed at the base of the display when in hold mode. That area of the display will be blank
when in Cont (continuous) mode.
OVER -
I08-0468 6/2013
INSTRUCTIONS
Process Black
White
White/Black MOTION PRO, INC. LOGO
Motion Pro, Inc.
867 American Street
San, Carlos, CA 94070
Tel: 650.594.9600 Fax: 650.594.9610
www.motionpro.com
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels